Morphy Richards Ultralight bagless vacuum cleaner manual Cleaning the filters, Changing the belt

73322 Rev 2 17/1/05 2:42 PM Page 6

Cleaning the filters

To maintain suction the pleated filter must be shaken clean each time the dust canister is emptied. Failure to clean the filter will reduce suction and could damage the motor if used for a prolonged period. This may invalidate the guarantee. If the filters become damaged they must be replaced.

Pleated filter

This must be shaken clean at every emptying to maintain suction. To thoroughly clean it wash it regularly.

To remove it from the dust canister lid turn the filter 1/4 turn anti-clockwise. H Wash in warm water (no detergent) and allow to air dry before refitting. The spare pleated filter allows one filter to be washed and dried whilst the other is in use.

G

Motor protection filter I

The motor protection filter Ò is located underneath the dust canister

1Remove the dust canister.

2Lift out the filter and shake over a dustbin.

The filter may also be washed in water

(no detergents) but must be totally dry before re-fitting.

3Replace the filter

Exhaust filter I

The exhaust filter is located below the dust canister compartment.

1Remove the front cover.

2Remove the exhaust filter Ú by pulling forward at the top and lift it away.

3Take the filter out of the cage and shake

vigorously over a dustbin. The filter may also be washed in warm water. Do not use detergents. The filter must be completely dry before re-fitting. Allow filters to air dry naturally.

4Replace the filter and front cover.

Changing the belt

If the brush bar stops rotating it is likely that the drive belt has snapped (usually because the brush has been stalled). A spare belt is supplied. Replacement belts can also be obtained from Morphy Richards.

Removing the floor nozzle cover JK

1Disconnect the cleaner from the mains supply.

H

	I
Ú	Ò

6