Motorola RFS6000, 1725-36197-001

Configuration Guide

PN: 1725-36197-001_A.doc

For configuring power and data rate settings, please consult your

facility’s RF site survey, designed for voice traffic, to determine if you

have sufficient coverage to support all data rates. SpectraLink

Wireless Telephones require the following minimum dBm reading to

support the corresponding Basic data rate setting in the access point.

802.11

Radio Standard Minimum Available

Signal Strength (RSSI) Maximum

“Basic” Data Rate

-70 dBm 1 Mb/s

802.11b -60 dBm 11 Mb/s

-63 dBm 6 Mb/s

802.11g -47 dBm 54 Mb/s

-60 dBm 6 Mb/s

802.11a -45 dBm 54 Mb/s

For additional details on RF deployment please see the Deploying

Enterprise-Grade Wi-Fi Telephony white paper and the Best

Practices Guide for Deploying SpectraLink 8020/8030 Wireless

Telephones.

Contents

Main Trademark Information Patent Information Copyright Notice Notice Contact Information Introduction Certified Product Summary Service Information Network Topology Configuration Settings Installing a New Image Installing firmware through the CLI Installing firmware through the Web interface Page Installing the AP license through the CLI Installing the AP license through the Web interface Configuring the Wireless Switch from the Default Configuration Radio Settings Configuring radio settings through the CLI When SpectraLink Wireless Telephones are configured for 802.11b & b/g mixed mode: When SpectraLink Wireless Telephones are configured for 802.11g only mode: When SpectraLink Wireless Telephones are configured for 802.11a mode: Channel selection For 802.11b/g radio: For 802.11a radio: Configuring radio settings through the Web interface Page Page Page SSID, QoS and Security Settings Configuring SSID, QoS and security settings through the CLI To configure WPA2-PSK replace the last two lines in the above command sequence with the following: Configuring SSID, QoS and security settings through the Web interface