Motorola RFS6000, 1725-36197-001

Motorola: RFS 6000 Wireless Switch with AP300

PN: 1725-36197-001_A.doc 1

5. To configure SSID, enter spectralink in the ESSID field.

6. To configure QoS, select the Enable SVP checkbox. This will

prioritize voice packets as instructed by the SVP protocol.

7. Select Low from the Access Category drop-down list. This will cause

all non-voice packets to get lower priority.

Contents

Main Trademark Information Patent Information Copyright Notice Notice Contact Information Introduction Certified Product Summary Service Information Network Topology Configuration Settings Installing a New Image Installing firmware through the CLI Installing firmware through the Web interface Page Installing the AP license through the CLI Installing the AP license through the Web interface Configuring the Wireless Switch from the Default Configuration Radio Settings Configuring radio settings through the CLI When SpectraLink Wireless Telephones are configured for 802.11b & b/g mixed mode: When SpectraLink Wireless Telephones are configured for 802.11g only mode: When SpectraLink Wireless Telephones are configured for 802.11a mode: Channel selection For 802.11b/g radio: For 802.11a radio: Configuring radio settings through the Web interface Page Page Page SSID, QoS and Security Settings Configuring SSID, QoS and security settings through the CLI To configure WPA2-PSK replace the last two lines in the above command sequence with the following: Configuring SSID, QoS and security settings through the Web interface