Motorola RFS6000, 1725-36197-001 Installing firmware through the Web interface

1 18

Configuration Guide

PN: 1725-36197-001_A.doc

Installing firmware through the Web interface

1. Open the RFS6000 applet by entering the IP address of the

wireless switch: http://192.168.2.103

2. In the navigation pane under Switch, click Firmware.

3. In the Firmware screen, click the Update Firmware button located at

the lower right of the page.

4. In the Update dialog box, select TFTP from the Using drop-down list.

5. At File, enter the RFS6000 firmware image filename.

6. At IP Address, enter the TFTP server IP address.

7. Click the Do Update button.

8. After the RFS6000 Wireless Switch performs the upgrade,

navigate to the Switch window.

Contents

Main Trademark Information Patent Information Copyright Notice Notice Contact Information Introduction Certified Product Summary Service Information Network Topology Configuration Settings Installing a New Image Installing firmware through the CLI Installing firmware through the Web interface Page Installing the AP license through the CLI Installing the AP license through the Web interface Configuring the Wireless Switch from the Default Configuration Radio Settings Configuring radio settings through the CLI When SpectraLink Wireless Telephones are configured for 802.11b & b/g mixed mode: When SpectraLink Wireless Telephones are configured for 802.11g only mode: When SpectraLink Wireless Telephones are configured for 802.11a mode: Channel selection For 802.11b/g radio: For 802.11a radio: Configuring radio settings through the Web interface Page Page Page SSID, QoS and Security Settings Configuring SSID, QoS and security settings through the CLI To configure WPA2-PSK replace the last two lines in the above command sequence with the following: Configuring SSID, QoS and security settings through the Web interface