8. Advanced settings
This setting is useful to access certain network and PABX/ switchboard services.
8.1Recall time
The default D1000 recall time is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so.
1.Press m, scroll dto ADVANCED SET and press m.
2.RECALL TIME is displayed. Press m.
3.Press uor dto select the setting you want: SHORT,
MEDIUM, LONG.
4.Press mto confirm.
5.Press >to return to standby.
NOTE
The use of your D1000 cannot be guaranteed on all PABX.
8.2Dial mode
The default D1000 dialling mode is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so.
1.Press m, scroll dto ADVANCED SET and press m.
2.Scroll dto DIAL MODE. Press m.
3.Press uor dto select TONE or PULSE.
4.Press mto confirm.
5.Press >to return to standby.
8.2.1 Temporarily switch from Pulse to Tone dialling
1. Press and hold *.
The dial mode will change from Pulse to Tone for the duration of the call.
8.3 Call barring
Prevent certain numbers from being dialled from your D1000. Store up to four specific numbers, each up to 4 digits
– for example, international or local prefixes.
Bypass call barring by switching the setting Off or On.
NOTE
If you switch Call barring on, BARR MODE ON will be displayed on your screen in standby mode.
8.3.1 Switch call barring on/off
1. Press m, scroll dto ADVANCED SET and press m.
2. Scroll dto CALL BARRING. Press m.
3. Enter the master PIN (default setting 0000) and press
m.
4.MODE is displayed. Press m.
28 | Advanced settings |
|
|
