Motorola D512, D513 Using additional handsets, Registering an additional handset, On the base

9. Using additional handsets

You can register up to five handsets to your D5 base to extend your phone system without having to install extension sockets for each new phone.

Each D5 handset can be registered with up to four bases. You can then select the base you prefer to use.

If you have purchased a D5 multiple pack, all additional handsets come pre-registered to the base.

If you have purchased an additional handset separately, you must register it to your D5 base before it can be used.

9.1Registering an additional handset

NOTE

Handset batteries must be fully charged before you start to register. Hold your handset close to the base during the registration process.

Handsets that were supplied with your D5 base are already pre-registered.

On the base:

1. Press and hold the pbutton for 3 seconds until you hear two beeps. The base will remain in registration mode for 90 seconds.

28

On the handset:

1.Press m, scroll dto REGISTER and press m.

2.Scroll dto REG BASE and press m.

3.Enter the base number (1 - 4).

The base numbers that are already in use flashes. The display shows SEARCHING....

4.When the handset finds the base signal, the display shows SEARCHING...X, where X indicates the base identification number.

5.The display will ask for the PIN to be entered. Enter the 4 digit PIN code (default = 0000) and press m.

You will hear a beep if the registration is successful. The handset is automatically assigned an available handset number. Use this number when making internal calls.

NOTE

If registration is not successful the first time, please repeat the process again in case the base registration period ran out of time. If the base is not found after a few seconds, the handset returns to standby. Try registering again.

If there are already 5 handsets registered to the base, the registration will fail. You must de-register another handset before you can register a new one.

Using additional handsets