3
Programming the Master Power Feature
If you wish to control the power on/off function of your receiver and TV, and all connected equipment with a single press of the POWER key on your remote control, you can enable the remote control’s Master Power feature by following these steps:
•Press the CBL key on the remote control for at least three seconds or until the light on the key blinks.
•Press the POWER key on the remote. The light will remain on steady. Press the power key a second time, and the light on the remote will blink on and off briefly, which indicates that the remote has accepted the Master Power command.
If you wish to cancel the Master Power feature, just repeat the steps outlined above.
Volume Control Crossover
Your remote control unit is programmed from the factory to control the volume of your television set when you are using the remote control in the CBL mode.
Verifying Your TV Mode Codes
You can verify the accepted programming codes for each mode by following these steps.
1.Press the TV key for at least three seconds or until the remote control unit LED blinks.
2.Press the "INFO" key.
3.The LED will blink, indicating the code of your TV, in the following sequence. For example, if your TV code is for a Tandy brand TV (code 105), the blink pattern will be:
-Pause>long blink "1;"
-Pause>short blink "0;"
-Pause>long blink, long blink, long blink, long blink, long blink "5." A zero in the code will always be represented by a short blink.
26
