Motorola MBP15 manual Registration, Paging

2.6Registration

The baby monitor is already pre-registered upon your purchase. You do not need to re-register it again unless the baby unit loses its link with the parent unit.

To re-register your baby monitor, follow the procedure below:

1.Switch off the baby unit mains power and remove the small power plug from the baby unit. Then, remove the batteries from the parent unit.

2.Press and hold Pwhile the baby unit mains power is switched back on, and keep holding it down until the night light flashes. The baby unit is in registration mode.

3.Press and hold Pwhile the batteries are replaced in the parent unit, and keep holding it down until the red sound LEDs flash. The parent unit is in registration mode.

4.Wait for the 2 units to search and establish the link.

When the registration is complete, the LEDs stop flashing and the parent unit emits a long beep.

2.7 Paging

If the parent unit is misplaced, press 3on the baby unit.

The parent unit will emit a repeated beep tone for 30 seconds so that you can locate it.

Press any key on the parent unit to stop paging.

ENGLISH

Getting started 11