Motorola 4.3 Test Frequencies for Display and Non-Display Radios

4-6 Transceiver Performa nce Testing
4.3 Test Frequencies for Display and Non-Display Radios
The radio channels and test frequencies are listed in Table 4-4. The chan ne ls ar e se lect ed usin g th e
channel selector switch located on top of the radio, as shown in Figure 4-1 on page 4-3. The test
environment an d channel spacing for any p articular frequency is selected using ‘side buttons 1 and 2’,
as listed in Table 4-1 on page 4-4 and Table 4-2 on page 4-5. The display radio shows the selected
parameters on the radio display, and sounds the corresponding number of beeps and tones listed in
Table 4-1and Table 4-1. The non-display radio only soun ds the beeps and tones.
Note: On UHF LTR models, radios must be in conventional or LTR modes.
Table 4-4: Test Frequencies (Using the Channel Selector Switch)
Channel
Selector
Switch
Position
Test
Channel Low 1 Low 2 VHF UHF 1 UHF 2 800
1 Low Power
8 High Power TX #1 or #8 RX #1 or #8 29.740 29.740 35.040 35.040 136.025 136.025 403.025 403.025 450.025 450.025 806.025 806.075
2 Low Power
9 High Power TX #2 or #9 RX #2 or #9 32.040 32.020 37.040 37.020 142.325 142.325 415.025 415.025 462.850 462.850 815.475 809.175
3 Low Power
10 High
Power
TX #3 or #10
RX #3 or #10 34.040 34.020 39.040 39.020 148.625 148.625 425.025 425.025 475.675 475.675 824.925 812.325
4 Low Power
11 High Power TX #4 or #11 RX #4 or #11 36.040 36.020 42.040 42.020 154.925 154.925 436.025 436.025 488.500 488.500 837.975 815.575
5 Low Power
12 High
Power
TX #5 or #12
RX #5 or #12 38.040 38.020 45.040 45.020 161.225 161.225 449.025 449.025 501.325 501.325 851.025 818.675
6 Low Power
13 High
Power
TX #6 or #13
RX #6 or #13 40.040 40.020 48.040 48.020 167.525 167.525 460.025 460.025 514.150 514.150 860.475 821.825
7 Low Power
14 High
Power
TX #7 or #14
RX #7 or #14 42.040 42.020 50.040 50.020 173.825 173.825 469.975 469.975 526.975 526.975 869.975 824.975