Operation

P110 Portable Radios

Operation

To Power-Up

Rotate the volume control 1/2 turn clock- wise to turn on the radio. A power-up alert tone is generated for approximately 1/8 second to indicate that the radio has passed a self-test of the microcomputer.

NOTE

If the short power-up alert tone is not gener- ated, or if a second low alert tone is generated (indicating corrupted radio programming), turn the radio off, check the battery (charge or replace if necessary), and turn the radio back on again. If the power-up alert tone is still not generated, a fault exists in the radio. Contact your local Motorola Radius dealer.

To Receive

1.Set the channel selector to the desired channel position.

2.Listen for a transmission and adjust the volume control to a comfortable listening level. If no transmission is heard, depress and hold the volume control button to unsquelch the radio and adjust the volume to a com- fortable listening level.

3.The radio is now set to receive all calls on the selected frequency.

4.If you wish to monitor a channel (disable PL/DPL) press the side mounted control button. If programmed as a Monitor Button, the LED glows yellow for 4 seconds to confirm that the coded squelch is disabled. Any time the PTT button is pressed when the P110 is in the mon- itor mode (disable PL/DPL), the LED temporarily glows yellow to remind you that this state is active. The radio remains in the monitor mode until the control button is pressed again, to reverse the state.

14

6880902Z28-E

March, 1996

Page 16
Image 16
Motorola P110 operating instructions Operation, To Power-Up, To Receive