Motorola RDU4100, RDV5100, RDU2020, RDV2020 manual Example of Programming Auto-Scan

•Short press the PTT button and move ahead to program the third digit. LED Indicator will blink red to indicate current value is ‘1’.

•Press the SB1 button to change the ‘third digit’ to ‘2’. Press the SB1 button to change again this ‘third digit’ to ‘3’. Radio will signal the chosen value.

•Long press the PTT button to save changes and return to 'Idle' Programming Mode.

•Once in 'Idle' Programming Mode, LED Indicator will start blinking a green heartbeat.

•Long press the PTT button to exit Programming Mode.

Example of Programming Auto-Scan

Auto-Scan is the last Programming Mode and can be set to either ON or OFF on a particular channel.

To set Auto-Scan to ON:

•Enter Programming Mode and select the desired channel (see Figure 1: Entering Programming Mode on page 37).

•Short press the PTT button six times to enter Auto-Scan Programming Selection Mode. The radio will signal beeps and will show the current Auto-Scan setting (please refer to “Reading Auto- scan Settings” on page 41).

•Short press the SB1 button to toggle ON/OFF the Auto-Scan feature in the channel. When ON, the LED Indicator will blink RED once. When OFF, the LED Indicator will blink ORANGE once.

PROGRAMMING FEATURES

45English