Cloning Radio using the Radio to Radio (R2R) Cloning Cable (Optional Accessory)
Operating Instructions
1.Before beginning the cloning process, make sure you have:
•A fully charged battery on each one of the radios.
•Two Single Unit Chargers (SUC).
•Turned OFF the radios and,
•Both radios are of the same radio model.
2.Unplug any cables (power supply or USB cables) from the SUCs.
3.Plug one side of the cloning cable mini connector to one SUC. Plug the other end to the second SUC.
Note: During the cloning process no power is being applied to the SUC. The batteries will not be charged. A data communication is being established between the two radios.
4.Turn ON the Target radio and place it into one of the SUCs.
5.On the Source radio, power the radio following the sequence below:
•Long press the PTT button and SB2 simultaneously while turning the radio ON.
•Wait for 3 seconds before releasing the buttons until a distinctive audible tone is heard.
6.Place the Source radio in its SUC, press and release SB1.
PROGRAMMING FEATURES
53English
