Motorola operation manual SG2-DRT-3X installed in SG2000

10STARLINE

Figure 11 illustrates the SG2000 equipped with an SG2-RPM/C, the E-pack cover removed, the ICS locations, proper cable routing and installed SG2-DRT-3X.

Figure 11

SG2-DRT-3X installed in SG2000

ICS connections

5Install an SG2-DR-3X input board in each selected ICS location. The ICS locations on the left are for ports 1 and 3 and the locations on the right are for ports 2 and 4.

6Nest the attached cables between the components on the E-pack and toward the PIC cable and status monitoring cable (optional).

7Position the cover on the E-pack and route the cables through the bottom opening following the PIC cable.

SG2-DRT-3X Installation Sheet