Preparing Your Radio for Use
4
Press downward on the cover to seat the lower tab properly into the RF connector.
Turn the thumbscrew clockwise to secure the connector cover to the radio.
To remove the universal connector cover, press down on the cover and turn the thumbscrew counterclockwise. Lift the cover up, slide the connector cover loop upwards, and remove it from the attached antenna.
Powering Up the Radio
Rotate the On/Off/Volume Control Knob clockwise until you hear a click. The LED blinks green.
A brief tone sounds, indicating that the power up test is successful.
NOTE: There is no power up tone if the radio tones/alerts function is disabled (see Turning
Radio Tones/ Alerts On or Off on page 24).
If your radio does not power up, check your battery. Make sure that it is charged and properly attached. If your radio still does not power up, contact your dealer.
To turn off the radio, rotate this knob counterclockwise until you hear a click.
Adjusting the Volume
To increase the volume, turn the On/
Off/Volume Control
Knob clockwise.
To decrease the volume, turn this knob counterclockwise.
English
