PROGRAMMING
TO PROGRAM YOUR NOMAD 2 CONTROLLER
1.Turn the Nomad power “OFF”
2.Hold both the ‘Find’ and ‘Stow’ buttons down and press the Power Button “ON”
3.Continue to hold ‘Find’ and ‘Stow’ button down for an additional 5 seconds after releasing the Power button
4.Release the ‘Find’ and ‘Stow’ buttons at this point and the front display lights will show the current satellite mode of the unit (Note: No Lights indicate “Dish Network NonSkewable mode.”
5.Use the ‘Find’ and ‘Stow’ buttons to cycle through the light (LED) patterns until the desired configuration is shown.
6.Turn the ‘Power’ off to store the programmed settings.
7.When you turn “Power” back on, it is recommended do a Test Dish or “Find” satellite.
14