First Time Setup
TO PROGRAM
Step 1:
Make sure your Nomad 2 is turned OFF:
ØNote: The Nomad 2 is OFF when the green light next to the power button is not lit.
Step 2:
Locate the FIND, STOW and POWER buttons on the Nomad 2:
ØRead the following steps carefully before beginning –
∙Press and hold down together the FIND and STOW buttons, while continuing to hold…..
∙Press the POWER button once and release
∙Continue holding down the FIND and STOW buttons for an additional 5 seconds.
ØThis will put the Nomad 2 into a Program Mode.
Step 3:
Refer to the Programming Options to determine what Program Mode settings you will need for the type of MotoSAT system you have:
ØUse the FIND or STOW button to navigate through the different settings on the front LED panel of the Nomad 2.
ØWhen the light configuration on the Nomad 2 matches the Programming Options press the POWER button to turn off the Nomad 2.
ØThis will store the configuration that you have set.
Step 4:
Turn on the Nomad 2 by pressing the POWER button. Wait 5 seconds for the Nomad 2 to perform startup sequences.
TEST DISH
Step 5:
To complete a “Test Dish”:
ØTurn power on
ØPush boththe FIND and STOW buttons at the same time.
ØYou will see the STOW light blink. It is indicating that the dish is moving.
ØWhen the Test Dish is completed, the STOW light will stop blinking and go solid.
TO LOCATE SATELLITE
Step 6:
Press the FIND button.
ØThis will locate your satellite(s) based upon the configuration settings that have been programmed.
5
