![Control panel](/images/new-backgrounds/61688/616885x1.webp)
Control panel
1
2
4
5
6
3
1- Power/Mode selector switch | 6- 2 automatic reheating positions: |
2- Defrost position | - Cup |
3- Time selector switch | - Soup plate |
4- grill position |
|
5- 3 combined microwave + grill cooking |
|
positions |
|
Installation
Preparation
Unpack the accessories, wash them and wipe them off carefully.
Position the ring bearing and then the turntable in the centre of the oven. GB
The turntable must be properly engaged with the drive.
Connecting
Check that the supply voltage marked on the type label glued on the rear of the appliance matches the voltage of your supply. The label indicates the nominal supply voltage of the appliance, e.g.
Ensure that the current marked on your electricity meter and circuit brea- ker/fuse is at least 16 Amperes.
Finally, for proper safety, it is essential to connect your appliance to an outlet socket with an earth connection in accordance with electrical instal- lation regulations and standards.
Position the appliance in such a way that the supply socket is readily acces- sible so that it can be easily disconnected.
You should also ensure that you can gain access to your circuit breaker/fuse.
It is imperative to comply with the above instructions regarding the electrical supply.
Position
Your appliance can be installed in one of two ways :
•On a
•In a niche : The niche must be at least 85 cm above
Adequate ventilation is essential: the minimum clearances are 20 cm above the oven and 10 cm at the sides and rear.
Install the appliance away from any source of heat such as a traditional oven or radiator. It has been design and tested for use in ambient temperatures up to 35°C.
Ensure that the ventilation holes of the appliance are not obstructed.
12