OPERATION
OPERATION
Operation Summary
The following is a summary of your Undercounter Dishwashing Machine operating cycle:
1.The cycle begins when you depress the front edge of the door latch toward the door.
2.The green cycle lamp lights and the pump starts.
3.The pump runs during the wash cycle for approximately 80 seconds. The wash cycle duration is extended if booster is not up to temperature.
4.The pump stops, and the drain is opened.
5.After a
6.After a
7.Within approximately 25 seconds, the rinse cycle is complete. The pump stops, the green cycle lamp turns off, and the cycle is complete.
8.Open the door and remove the rack of clean ware. The door must remain open for 5 seconds to allow the timer to reset before starting another cycle.
Operation Procedures
The operation of your dishwasher will be more efficient when these procedures are followed:
1.Check that the spray arms and scrap screen are in place.
2.Close the door and depress the front edge of the door latch toward the door. Push the ON/FILL switch to the ON position. The tank will begin filling with water. This procedure is followed only when the tank is empty.
3.When the tank is full, check the wash tank temperature gauge. Minimum wash temperatures are:
•501HT, 501HTN - 66°C/150°F.
•501LT - 60°C/140°F.
4.Scrap and preflush all items to be washed, and load the items into the rack. DO NOT OVERLOAD the rack. Wash only one layer of silverware in a rack.
5.Open the door and insert the rack into the machine.
6.Shut the door, and depress the door latch. This will start the wash cycle. The green cycle lamp located on the front control panel will light. This lamp will remain on until the entire wash and rinse cycle is completed.
8
