SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1.Plug the power cord into a standard electrical outlet. The clock will flash on the control panel to indicate that the time has not been set yet.
2.Press and hold the HOUR and then the MINUTE buttons until you reach the current time. The AM or PM indicator will light at the bottom of the display (Figure A).
The clock is now set!
NOTE: Pressing any button before setting the clock will cause the clock to start keeping time from 12:00 a.m. You must set the clock if you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply press the SET DELAY button (Figure B) and, while the DELAY BREW yellow light is flashing, set the delay brew time by pressing the HOUR and then the MINUTE buttons (Figure C). The AM or PM indicator will light at the bottom of the clock display.
Within a few seconds the display will change to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see the Brewing Coffee Later section.
To check the programmed time, push the SET DELAY button. The display will show the time you have programmed the coffee to brew. If you press the SET DELAY button again or wait a few seconds,
