WARNING
FIRE
HEATER OPERATION
START
1.The HERO heater is equipped with a blower fan switch, located on the control panel of the heater. Press the on/off switch to start the blower fan. Once the fan has been turned on, the green LED light on the control panel will turn on solid, indicating that the fan is operating. The blower fan must be turned on before the gas/igniter valve is SLOWLY pressed to light the heater.
CAUTION: Failure to start the fan prior to gas ignition may damage the heater. Always confirm that the fan is operating before igniting the heater.
2.Open propane supply valve on propane tank slowly. Note: If not opened slowly,
3.After the blower fan has been started, SLOWLY depress the orange gas/igniter valve button located on the control panel to ignite the heater. Keep the valve depressed for
WARNING: Be sure motor and fan are running before pushing in gas/igniter valve button. Flames could flash outside heater or internal damage to heater may result if motor and fan are not running.
SAFETY SHUT DOWN FEATURE
When the heater detects a power source change (connect or disconnect AC power while operating) it will automatically shut down. After shut down, the "START" procedure will have to be used to restart the heater.
STOP
1.Press the on/off switch to turn off the heater.
2.Turn off gas supply when heater is not in use.
MAINTENANCE AND STORAGE
1.The heater should be inspected before each use, and at least annually by a qualified person.
2.Before each use, check the soft "O" ring seat at the bullnose of the POL fitting. If the "O" ring is cut, scuffed, or otherwise damaged, replace it with part number F273786.
3.Turn off the gas at the
4.When the heater is to be stored indoors, the connection between the
5.It is recommended that the internal battery be maintained on a constant charge by leaving it plugged into a 120V power source.
6.The heater may be stored with the charger disconnected if all of the following conditions are met.
•The battery is fully charged before storing. (Failure to store fully charged will shorten battery life.)
•The average temperature of the storage location is below 50° (10°C).
•Storage duration is less than 6 months.
SERVICING
A hazardous condition may result if a heater is used that has been modified or is not functioning properly. When the heater is working properly:
*The flame is contained within the heater.
*The flame is essentially blue with perhaps some yellow tipping.
*There is no strong disagreeable odor, eye burning or other physical discomfort.
*There is no smoke or soot internal or external to the heater.
*There are no unplanned or unexplained shut downs of the heater.
The parts lists and exploded view show the heater as it was constructed. Do not use a heater which is different from that shown. In this regard, use only the hose, regulator and cylinder connection fitting (called a POL fitting) supplied with the heater. IMPORTANT Match the color stripe on the hangtag attached to the hose assembly with the color on the label located near the propane inlet fitting on the heater. Do not use alternates. For this heater, the regulator must be set as shown in "specifications". If there is any uncertainty about the regulator setting, have it checked.
A heater which is not working right must be repaired, but only by a trained, experienced service person.
Forced Air Propane Construction Heater | Operating Instructions and Owner’s Manual |
