CHAPTER I
INTRODUCTION
1. EQUIPMENT
This heater is the consumer version of a highly success- ful, thoroughly tested, gas fired, infrared, industrial utility heater.
This heater does not require an external electrical source for operation.
The major components of the heater and a typical installation are identified in Figure 1. The basic heater
consists of the complete burner assembly, flue deflector, grid, reflector assembly and face guard.
2. PURPOSE OF EQUIPMENT
WARNINGS
This heater is for indoor installation only.
This heater is designed to heat indoor areas. Do not use for inhabited or small, enclosed areas.
This heater is an ideal selection when a simple and
easily installed method of heating a utility building is required.
GAS CONTROL
VALVE
POWERPILE
GENERATOR
EXHAUST VENT
THERMOSTAT
CABLE
BASIC HEATER
WALL MOUNTING
BRACKET
THERMOSTAT
Figure 1. Heater Major Components
3. MODELS COVERED IN THIS MANUAL
Model MH25NG/HS25NG is for use where natural gas is intended fuel source. Model MH25LP/HS25LP is for use where propane gas is the intended fuel source.
4.MANUAL USE
•The procedures and information contained within
this manual will allow purchaser of this heater to install and maintain the heater safely and efficiently.
•The cover and the following page provide a safety summary that attempts to gather all the warn- ings used within the manual in one location.
•A table of contents is provided for easy reference to any portion of the manual.
•Chapter 1 provides general information on the use of this manual and on the heater.
Model # MH25NG/LP | HS25NG/LP | 3 | Installation instructions and Owner’s Manual |
