Open

Equipment

Closed

Shutoff Valve

 

Figure 13

Control Valve

Gas Meter

Equipment

Shutoff Valve

Figure 14

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.­

A.This appliance has a pilot that must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call you gas supplier from a neigh- bor’s phone. Follow the gas supplier’s instruc- tions.

•If you can not reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. It knob will not push in or turn by hand, don’t try to repair it; call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been underwater. Immediately call a qualified ser- vice technician to inspect the appliance and to replace any part of the control system which has been underwater.

LIGHTING INSTRUCTIONS

1.STOP! Read the all safety information included with and on the side of heater.

2.Check that gas supply to heater is on.

3.Push in gas control knob and slightly turn clock- wise to the OFF position (see figure 16).

Note: Knob cannot be turned from PILOT to OFF unless knob is pushed in slightly. Do not force.

4.Wait five (5) minutes. Then smell for gas, in- cluding near the floor. If you smell gas, STOP! Follow “B” in the safety information above. If you do not smell gas, go to the next step.

5.Push in gas control know slightly and turn counterclockwise to PILOT/IGN and depress for five (5) seconds.

Note: The first time that the heater is operated after connecting the gas supply, the control knob should be depressed for about 30 seconds. This will allow air to bleed from the gas system.

6.Push in control knob and rotate control knob back to OFF position then rotate counterclock- wise to PILOT/IGN position. This will light pilot. If needed gently keep rotating control knob back and forth while depressed until pilot lights.

7.Keep control knob depressed in for ten (10) seconds after lighting pilot. If pilot goes out, repeat steps 4, 5, 6 and 7.

•If pilot does not stay lit, refer to Troubleshoot- ing, pages 14 & 15. Also, contact a qualified service person or gas supplier for repairs.

•If control knob does not pop up when released, contact a qualified service person or gas sup- plier for repairs.

•When the pilot is lit, turn the control knob to “HI” position to light heater.

•After flame is established (see Burner Flame Pattern, Pages 12 and 13) on “HI”, adjust heat output by turning control knob to desired position (“LO” or “HI”). Do not operate heater between locked positions.

Unvented LP-Gas Fired Buddy Wall-Mount Heater

9

Installation Instructions and Owner’s Manual

Page 8 Page 10
Page 9
Image 9
Mr. Heater MHVFB10LP installation instructions Lighting Instructions, For Your Safety Read Before Lighting
Page 8 Page 10

MHVFB10LP specifications

Mr. Heater MHVFB10LP is a powerful and efficient portable propane heater designed for optimal performance in a variety of outdoor and indoor applications. This innovative heating solution is ideal for individuals looking to warm large spaces, such as garages, workshops, and various outdoor events. With its user-friendly design and advanced technology, the MHVFB10LP delivers both comfort and convenience.

One of the standout features of the MHVFB10LP is its impressive heating capacity, providing up to 10,000 BTUs of heat. This output can effectively warm areas up to 225 square feet, making it an excellent choice for both small and moderately sized spaces. The heater has a high-efficiency rating, achieving a 99.9% fuel efficiency, which ensures that users get the most out of their propane supply.

The MHVFB10LP is equipped with an adjustable heat setting, allowing users to customize their heating experience as needed. Whether you need a gentle warmth or a significant boost in temperature, this heater can easily accommodate your requirements. Additionally, the radiant technology utilized in this heater provides warm, even heat across the given space, ensuring a comfortable environment.

Safety is paramount when it comes to heating solutions, and Mr. Heater has incorporated various safety features into the MHVFB10LP. The heater is designed with an automatic shut-off feature that activates if the unit is tipped over or if it detects a low oxygen level. This provides peace of mind for users, allowing them to focus on enjoying their space without undue concern.

The portability of the MHVFB10LP is another noteworthy characteristic. Weighing in at a manageable size, the unit features a convenient carrying handle, allowing users to easily transport it from one location to another. This makes it ideal for camping trips, tailgating events, and workshops alike.

Furthermore, the MHVFB10LP is designed for easy operation, featuring an integrated piezo igniter that allows for quick starts without the need for matches or lighter fluid. This ensures that users can enjoy warmth almost instantly.

In summary, the Mr. Heater MHVFB10LP is a versatile, efficient, and safe propane heater that meets the heating needs of a wide array of users. From its powerful heating capacity and adjustable settings to its safety features and portability, the MHVFB10LP stands out as an essential tool for comfort in both work and leisure activities. Whether you’re looking to ward off the chill on a cold day or need a reliable heat source for your outdoor adventures, this heater delivers exceptional performance.
Top Page Image Contents