Controls and Features

4

 

 

 

Tine Clutch

Control

Clutch Cable

Recoil Starter

Handle Knobs

Back of Tiller

 

Tines

Depth

Front Wheel

Stake

 

 

Figure 4-1

Tine Clutch Control

Front Wheel

The clutch control lever is located on the upper handle. Squeezing the lever against the handle engages the tine drive. Release the lever to stop the tines from turning.

Handle Knobs

The handle height may be adjusted. Loosen the knobs and remove the carriage bolts to change the position. Reinstall and tighten the hardware when complete.

Recoil Starter

The recoil starter is located on the engine and is used to manually start the engine.

Depth Stake

The depth stake acts as a brake for the tiller and controls the depth and speed at which the machine will operate.

The front wheel can be raised and lowered for transport and storage. Refer to the Assembly & Set-Up Section for instructions.

Engine Controls

Refer to engine manual for additional information and functions of the engine controls.

Throttle Control (If Equipped)

The throttle control lever is located on the engine. It controls the engine’s speed and stops the engine.

Primer

The primer, located on the engine, is used to pump gas into the carburetor and aid in starting the engine. Use it to start a cold engine, but do not use it to restart a warm engine after a short shutdown.