7
If the snow thrower will not be used for 30 days or longer, or if it is the end of the snow season when the last pos- sibility of snow is gone, the equipment needs to be stored properly. Follow storage instructions below to ensure top performance from the snow thrower for many more years.
Off-Season
Storage
WARNING
Never store snow thrower with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or
gas appliance.
Fuel left in engine during warm weather deteriorates and will cause serious starting problems.
Never use engine or carbu- retor cleaning products in the fuel tank or permanent damage may occur.
Preparing Engine
NOTE: Refer to the engine manual for more detailed information on preparing the snow thrower engine for storage.
It is important to prevent gum deposits from forming in essential fuel system parts of the engine such as the carburetor, fuel filter, fuel hose, or tank during
Fuel stabilizer (such as
WARNING: Never store snow thrower with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark or pilot
light as on a furnace, water heater, clothes dryer or gas appliance.
CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be emptied before storage for 30 days or longer.
WARNING: Fuel left in engine during warm weather deteriorates and will cause serious starting problems.
1.Run the engine until the fuel tank is empty and it stops due to lack of fuel. Do not attempt to pour fuel from the engine.
WARNING: Never use engine or carbu- retor cleaning products in the fuel tank or permanent damage may occur.
2.Remove the spark plug and pour one (1) ounce of engine oil through the spark plug hole into the cylinder. Cover spark plug hole with a rag and crank the engine several times to distribute the oil. Replace spark plug.
Preparing Snow Thrower
•When storing the snow thrower in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings and cables.
•Remove all dirt from exterior of engine and equipment.
•Follow lubrication recommendations.
•Store equipment in a clean, dry area.
22
