5 | 1 | 2 |
|
Setting Up
Your Snow
Thrower
NOTE: Reference to right and left side of the machine are observed from the operating position.
NOTE: This Operator’s Manual covers several models. Snow thrower features vary by model. Not all features discussed in this manual are applicable to all snow thrower models.
NOTE: Two replacement auger shear pins and bow tie cotter pins are provided for your convenience. Store in a safe place until needed. Refer to “Augers” in the Maintenance Section of this manual for more information.
1.Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward.
2.Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only.
3.Position the chute assembly over the base.
4.Close the flange keepers to secure the chute assembly to the chute base. The flange keepers will click into place when properly secure.
NOTE: If the flange keepers will not easily click into place, use the palm of your hand to apply swift, firm pressure to the back of each.
3
4 
