3.7.Safely support rear of the unit so that the rear wheels are off the ground, and remove rear hub caps. See Figure 3.7.
4X4supports
Figure 3.7
3.8.Using a 1/2” wrench and a 9/16” wrench remove the shoulder bolts, washers, and rear wheels. See Figure 3.8.
Dust cover
Heavy washer
Figure 3.8
NOTE: A heavy washer goes between wheel and outside of frame.
3.9.
NOTE: The rear cross bar is shorter than the front cross bar.
3.10.Remove retaining ring holding drive gear and dowel pin on axle. See Figure 3.10.
Dust cover
Right hand drivegear
Figure 3.10
NOTE: There are right hand and left hand drive gears
3.11.Remove dust cover
NOTE: Rim on dust cover faces outboard
3.12.Remove
Flat washer
Bushing
Figure 3.12
6