3.13.Remove three self tapping screws holding trans- mission brace to the frame using an 3/8 socket.
3.14.Remove the two phillips screws holding the transmission to the brace. See Figure 3.14.
Self tapping screws
Phillips screw
Figure 3.14
3.15.Remove barbed fitting holding the variable speed cable to the transmission bracket. See Figure 3.15.
Variable speed cable
Barbed fitting
Figure 3.15
3.16.Disconnect
NOTE: Rotating the collar
NOTE:
3.17.Remove spring from transmission actuating arm. (This is the self propel clutch cable)
Actuating arm
Self propel clutch cable
Figure 3.17
3.18.Push the hexagonal drive axle bushings out of each side of frame. See Figure 3.18.
Bushing
Figure 3.18
7