2.11.Confirm that the drive gears are installed on the correct side. See Figure 2.11.
Right hand drive gear
Figure 2.11
NOTE: There is an “R” on the right side gear and an “L” on the left side gear.
2.12.Remove retaining ring and gear to assure dowel pin is in place. See Figure 2.12.
Right side gear
Drive axle
Pin
Figure 2.12
NOTE: The pin must be free to slide back and forth. This provides a ratcheting action.
NOTE: Apply
3.TRANSMISSION REMOVAL
3.1.Disconnect the H.T. lead from the spark plug.
3.2.Remove collection bag or blower chute.
3.3.Remove vacuum hose if attached.
3.4.Using a 3/8” socket, remove the 3 self tapping screws securing the belt cover. See Figure 3.4.
Self tapping screws
Figure 3.4
3.5.Insert a 3/8” breaker bar and extension into the square hole of the tensioner arm.
Tensioner
Arm
Square hole
Figure 3.5
3.6.Pull the breaker bar rearward until the drive belt can be slipped over the variable pulley easily
5