4.7.Use a 1/4” wrench to remove the three Screws securing the black plastic nozzle to the lower housing. They are accessible from underneath. See Figure 4.7.
Black plastic nozzle
1/4” Screws
Figure 4.7
4.8.Four phillips head screws secure the front of the nozzle to the frame. Remove them.
Nozzle Mounting
Screws
Figure 4.8
4.9.Tilt top of black plastic nozzle toward the engine to remove. This will allow the safety gate to pass by the hose opening freely. See Figure 4.9.
Nozzle
Engine
Safety gate within vacuum tube
Figure 4.9
4.10.Remove all of the fasteners holding the lower housing to the upper housing. See Figure 4.10.
Lower housing
Nut & bolt
Figure 4.10
NOTE: There is a variety of nuts, bolts, and self- tapping screws holding the two housings together.
9