Self-propelled Chipper Shredder Vacuum

3.19.Pivot transmission rearward while sliding it to the right. See Figure 3.19.

Self propelled transmission

Figure 3.19

3.20.Once the left side comes out, slide the transmis- sion to the left. At this point the transmission will be solely in your hands

3.21.Install new transmission in opposite order that was taken out.

4.IMPELLER AND BELT REMOVAL

4.1.Disconnect the H.T. lead from the spark plug.

4.2.Remove the transmission as described in the TRASMISSION REMOVAL section of this man- ual.

4.3.Safely tilt and support the front of unit to provide access to the front wheel and nozzle mounting hardware.

4.4.Remove the hub caps.

4.5.Remove front wheels using an 1/2 wrench.

4.6.Using a 15/16” wrench and a 9/16” wrench remove height adjusters and cross bar. See Figure 4.6.

Height adjuster

Crossbar

Figure 4.6

NOTE: The front cross bar is longer than the rear cross bar

8