Mounting The

Undercarriage Assembly

1. Remove and retain the four hairpin clips from the weld pins found on the top side of the undercarriage

assembly. Remove and retain the two clevis pins with

hairpin clips. This hardware is for later installation. See Fig. 4-5.

2. With the undercarriage assembly beneath the tractor,

see Fig. 4-6, lift the undercarriage assembly upFigure 4-7against the frame of the tractor. The weldpins on the

top of the undercarriage assembly should go through the aligning holes found along the tractor’s frame. See Fig. 4-7.

3.Fasten the undercarriage assembly to the frame with the hairpin clips removed in step 1. See Fig. 4-8

4. Route the upper drive belt around the engine pulley. See Fig. 4-7.

NOTE: Proceed to the Assembling Controls section of this manual if you have an Electric PTO.

5.Attach the extension spring to the idler pulley. See Fig. 4-9. Connect the other end to tractor’s frame rail. See Fig. 4-10.

Figure 4-8

Figure 4-5

Figure 4-9

Figure 4-6

Figure 4-10

4

Assembly

&Attaching Undercarriage

WARNING

Before installing attachment, place tractor on a firm and level surface. Place the PTO in

the disengaged

(OFF) position, set the parking brake, shut engine off and remove key to prevent unintended starting.

11