Heat Shield

Figure 6-5

IMPORTANT: It will be necessary to have a second person assist you to complete the following steps.

1.Install a shoulder bolt on each side of the tractor and secure with a lock nut, as seen in Fig. 6-7

2.Position the auger housing assembly in front of the tractor as seen in Fig. 6-6. Lay the belt and support tubes on the installation surface.

3.Carefully move the tractor forward (by pushing, NOT driving it) so that support tubes found on the rear of the auger housing assembly are positioned between the tractor’s front tires. Set the parking brake.

4.With the help of an assistant, lift up the auger housing and move it so that it rests over the shoulder bolts installed in Step 1 of this section. See Fig. 6-7.

5.Maneuver the auger housing until the mounting holes line up. Insert the two quick release pins from your hardware pack into the top hole on each side as seen in Fig. 6-8.

Attaching Support Tubes

1.Secure the left support tube to the front of the undercarriage assembly with the clevis pin and hairpin clip removed earlier. See Fig. 6-9.

2.Repeat the previous step on the right side.

Belt

Support Tube

Figure 6-6

Attaching Reflectors

Peel off the backing from each of the reflectors to expose the adhesive surface. Adhere the reflectors to the rear of the tractor’s fender (one on the left and one on the right) so that the reflectors simulate taillights.

Shoulder Bolt

Figure 6-7

Quick Release Pin

Figure 6-8

Figure 6-9

6

Mounting

Auger

Housing

WARNING

Before installing attachment, place tractor on a firm and level surface. Place the PTO in the disengaged (OFF) position, set the parking brake, shut engine off and remove key to prevent unintended starting.

13