Making Adjustments

WARNING: Never attempt to make any adjustments while the engine is running, except where specified in the Operator’s Manual. Place tractor on a firm and

level surface. Place the PTO in the disengaged (OFF) position, set the parking brake, shut engine off, and remove key to prevent unintended starting.

Lift Adjustment

If the lift index rod doesn’t latch securely or the pivot release has too much slack in it, an adjustment can be made as follows:

1.Loosen the upper hex nut a few turns, then tighten the lower hex nut to shorten the cable length. See Fig. 11-1.

2.Loosen the lower hex nut a few turns, then tighten the upper hex nut to lengthen the cable. See Fig. 11-1.

Lower Chute Crank

Support Bracket Adjustment

If the spiral at the base of the lower chute crank isn’t fully engaging with the notches in the lower chute assembly, the support bracket can be adjusted inward or outward as follows:

1.Loosen, but do NOT remove the two hex nuts which secure the support bracket to the snow thrower housing. See Fig. 11-2.

2.Adjust the support bracket inward or outward so that the spiral is fully engaged in the notches on the chute before retightening the hex nuts.

Skid Shoe Adjustment

The space between the shave plate and the ground can be adjusted by repositioning the skid shoes found on either side of the snow thrower’s auger housing. For close snow removal, place skid shoes in the low position. Use a middle or high position when the area to be cleared is uneven.

IMPORTANT: It is NOT recommended that this snow thrower be operated on a gravel surface, as loose stones can be easily picked up and thrown by the machine. If you must operate on a gravel surface, ALWAYS adjust the skid shoes into the HIGH position to allow the shave plate maximum clearance.

Adjust skid shoes as follows:

1.Loosen, but do NOT remove, the three hex nuts which fasten the skid shoe to the auger housing.

See Fig. 11-3.

2.Raise or lower the skid shoe to desired position.

NOTE: Make certain the entire base of both skid shoes are against the ground to avoid uneven wear on the skid shoes. When one side does wear out, the skid shoes are reversible.

3.Retighten the hex nuts loosened earlier.

4.Repeat this adjustment on the skid shoe found on the opposite side of the snow thrower.

Hex Nuts

Lift Cable

Lift Index Rod

Figure 11-1

Spiral

Hex Nuts

Support

Bracket

Figure 11-2

Skid Shoe

Hex Nut

Figure 11-3

10

Adjustments

WARNING

Never attemptto make anyadjustments whilethe engine is running,except wherespecified in the

Operator’s Manual. Place tractor on a firm and level surface. Place the PTO in the disengaged (OFF) position, set the parking brake, shut engine off, and remove key to prevent unintended starting.

17