7.Carefully tilt and support the unit up to provide access underneath to the nozzle mounting hardware and impeller. Remove the three shoulder bolts securing the black plastic lower flail housing to the lower housing. Refer to Figure
8.Tilt top of black plastic lower flail housing toward the engine to remove.
9.Using a 3/16” allen wrench, remove the flat head cap screws that hold the chipper blade to the impeller. These screws are accessible through the opening created when the chipper chute was removed earlier. See Figure
10.The nuts on the flat head cap screws can be reached from underneath using a
11.Replace or sharpen chipper blade. The blade can be sharpened with a file or on a grinding wheel.
12.When sharpening blade, protect hands by using gloves and follow the original angle of grind.
13.Reassemble by performing the previous steps in the opposite order and manner of removal.
NOTE: Tighten blade screws to 210 - 250
Off Season Storage
•When storing the yard vacuum in an unventilated or metal storage shed, care should be taken to rustproof the
•Remove all dirt from exterior of engine and equip- ment.
•Follow lubrication recommendations.
•Refer to engine manual for correct engine storage instructions.
•Store equipment in a clean, dry area. Do not store in an area where equipment is present that may use a pilot light or has a component that can create a spark.
Black Plastic
Nozzle
Shoulder Screws
Figure
Flat Head Cap Screws
Chipper Blade
Figure
Impeller
Nuts
Figure
5
Maintaining
Your
Chipper
Shredder
Vacuum
17