Replacing Auger Paddles

The snow thrower auger’s rubber paddles are subject to wear and should be replaced if any signs of excessive wear is present.

Caution: Do NOT allow the auger’s rubber paddles to wear to the point where portions of the metal auger itself can come in contact with the pavement. Doing so can result in serious damage to your snow thrower.

To change the rubber paddles, proceed as follows:

1.Remove the existing rubber paddles by unthreading the self-tapping screws which secure them to the auger. See Figure 7-3.

Figure 7-3

2.Secure the replacement rubber paddles to the auger using the hardware removed earlier.

Replacing Shave Plate

The shave plate is attached to the bottom of the auger housing and is subject to wear. It should be checked periodically. There are two wearing edges and the shave plate can be reversed.

1.Remove the four carriage bolts and hex lock nuts which attach it to the snow thrower housing.

2.Install new shave plate, making sure the heads of the carriage bolts are on the inside of the housing.

3.Adjust the shave plate as instructed on page 11. Refer to Figure 6-1.

4.Tighten securely once adjusted.

Section 7 — Service

 

13