Troubleshooting | 8 |
| |
|
|
Problem |
| Cause |
| Remedy |
|
|
|
|
|
|
|
|
|
|
Engine Fails to start | 1. | Fuel tank empty, or stale fuel. | 1. | Fill tank with clean fresh gasoline. |
| 2. | Improper fuel mixture. | 2. | Mix new fuel at a ratio of 50:1. |
| 3. | Blocked fuel line. | 3. | Clean fuel line. |
| 4. | Key not in ON position. | 4. | Insert key and turn to ON position. |
| 5. | Spark plug wire disconnected. | 5. | Connect wire to spark plug. |
| 6. | Faulty spark plug. | 6. | Clean spark plug, readjust gap, or replace. |
| 7. | Engine not primed. | 7. | Prime engine four times. |
| 8. | Engine flooded from excessive priming. | 8. | Wait at least ten minutes before starting. |
|
|
|
|
|
Engine runs erratic | 1. | Unit running on choke. | 1. | Move choke lever to OFF position. |
| 2. | Fuel line blocked, or stale fuel. | 2. | Clean fuel line and fill tank with fresh, clean |
|
|
|
| gasoline. |
| 3. | Water or dirt in fuel system. | 3. | Refer to engine manual for remedy. |
| 4. | Carburetor out of adjustment. | 4. | Refer to engine manual for remedy. |
|
|
|
|
|
Engine overheats | 1. | Carburetor out of adjustment. | 1. | Refer to engine manual for instruction. |
|
|
|
|
|
Loss of power | 1. | Spark plug wire loose. | 1. | Firmly connect spark plug wire. |
| 2. | Vent in gas cap plugged. | 2. | Clear vent. |
|
|
|
|
|
Excessive vibration | 1. | Loose parts or damaged auger. | 1. | Stop engine immediately and disconnect |
|
|
|
| spark plug wire. Check for possible damage. |
|
|
|
| Tighten all bolts and nuts. Repair as needed. |
|
|
|
| If the problem persists, take unit to an |
|
|
|
| authorized service dealer. |
|
|
|
|
|
Unit fails to | 1. | Drive cable out of adjustment. | 1. | Adjust auger control cable as shown in |
|
|
|
| Maintanence and Adjustments section. |
| 2. | Drive belt loose or damaged. | 2. | Replace drive belt. |
|
|
|
|
|
Augers continue to rotate | 1. | Cable out of adjustment. | 1. | Adjust auger control cable as shown in |
|
|
|
| Maintenance and Adjustments section. |
|
|
|
|
|
Unit fails to discharge snow | 1. | Chute assembly clogged. | 1. | Stop engine and disconnect spark plug wire. |
|
|
|
| Clean chute and inside of auger housing with |
|
|
|
| |
| 2. | Shear pin sheared. | 2. | Replace shear pin. |
| 3. | Foreign object lodged in auger. | 3. | Stop engine immediately and disconnect the |
|
|
|
| spark plug wire. Remove object from auger. |
| 4. | Auger control cable out of adjustment. | 4. | Adjust auger control cable. |
| 5. | Auger belt loose or damaged. | 5. | Replace auger belt. |
14