Manuals / Brands / Computer Equipment / Network Card / Multi-Tech Systems / Computer Equipment / Network Card

Multi-Tech Systems MT5634IND Step 2 – Connect the Modem to Your System, For AC Power, For DC Power, RS-232Connection, Power Connection, Phone Line Connection

1 28

Download 28 pages, 335.63 Kb

Chapter 2 – Installation

Step 2 – Connect the Modem to Your System

For AC Power

Turn off your computer. Place the modem in a convenient location, and then connect it to your computer’s serial port, the phone line, and AC power.

For DC Power

For DC power, use the fused cable in place of the Universal Power Supply and the AC Power Cord.

Fused	Fused Cable
Cable	Connection

Steps for connecting Your Modem to Your SystemRS-232 Connection

Plug one end of the serial cable into the RS-232 connector on the modem, and plug the other end into a serial port connector on your computer, such as COM1 or COM2.

Phone Line Connection

Plug one end of the phone cable into the MT5634IND LINE jack and the other end into a phone line wall jack.

Power Connection

For AC

Plug the power supply cable with attached transformer block into the power connector on the MultiModem. Then plug the AC cord receptacle into the transformer block, and plug the other end of the of the AC cord into a power outlet or power strip.

Note: Use only the power supply supplied with the MT5634IND. Use of any other power supply will void the warranty and could damage the modem.

For DC

Plug the fused cable into the power connector on the MultiModem. Then attach the two wires at the other end of the fused cable to a DC power source.

Multi-Tech Systems, Inc. MT5634IND User Guide (S000369A)

10

Contents

Page Page Contents Page Chapter 1 – Description and Specifications Introduction Safety Warnings MultiModem Package Contents Features and Technical Specifications Electrical Specifications LED Indicators RS-232 9-PinConnector About the Leased-LineOperation Feature Setup Chapter 2 – Installation Step 1 – Desktop Placement or Panel- Mounting Step 2 – Connect the Modem to Your System Step 3 – Install the Modem Driver Step 4 – Configure the Modem for Your Country or Region Using the Global Wizard Using AT Commands Step 5 – Install Data Communications Software Chapter 3 – AT Commands, S-Registers and Result Codes Chapter 4 – Remote Configuration Basic Procedure Setup Changing the Setup Password Changing the Remote Escape Character Chapter 5 – Callback Security Changing the Setup Password Turning Callback Security On and Off Setting Callback Security Message Parity Assigning Callback Passwords and Phone Numbers Calling Procedures Password-OnlyCallback Number-EntryCallback Extension-EntryCallback Direct Connection Callback Security Commands Chapter 6 – Troubleshooting None of the Indicators Light The Modem Does Not Respond to Commands The Modem Cannot Connect When Dialing The Modem Disconnects While Online Modem Cannot Connect When Answering File Transfer Is Slower Than It Should Be Data Is Being Lost There Are Garbage Characters on the Monitor The Modem Doesn’t Work with Caller ID Fax and Data Software Can’t Run at the Same Time Appendix A – Flash Upgrade Appendix B – Regulatory Compliance EMC, Safety, and R&TTE Directive Compliance International Modem Restrictions Telecom Requirements for the United States FCC Part 15 Regulation New Zealand Telecom Warning Notice South African Statement Other Appendix C – Multi-TechWarranty Statement and Product Repair Warranty Online Warranty Registration Product Repair Repair Procedures for U.S. and Canadian Customers Repair Procedures for International Customers (Outside U.S.A. and Canada) Repair Procedures for International Distributors Replacement Parts Index