PS9600 Power Supply User Guide
Introduction
This manual describes the field installation of a
Description
The PS9600 is a universal input switching power supply for the CommPlete Communications Server. Two PS9600 power supplies are installed as standard equipment in each CommPlete CC9600 chassis. The outputs of the two power supplies are connected in parallel to the CC9600 chassis power bus. If any of the outputs on either power supply fails or is too low, the other power supply takes over with no switchover time, and supplies all the power required to run the system. (This assumes that both power supplies are turned on.)
Figure 1. PS9600 power supply.
Features
•Dual redundant, universal input switching supply.
•Front panel on/off switch and power LED indicator.
•Power LED lights only if all outputs are good.
•Outputs paralleled for redundancy.
•No switchover time for redundant supply takeover.
•Short circuit protection on all outputs.
•
•Logic level output signal for “All voltages OK.”
2 | CommPlete Communications Server |
