BP-25H CE GASOLINEVIBRATOR — MAINTENANCE

Engine Air Cleaner

1.Press the latch tabs on the top of the air cleaner cover and remove the cover and foam filter element as shown in Figure 24.

2.Clean foam element in warm, soapy water or nonflam- mable solvent. Rinse and dry thoroughly. Dip the element in clean engine oil and completely squeeze out the excess oil from the element before installing.

DANGER - EXPLOSIVE FUEL HAZARD

DO NOT use gasoline as a cleaning solvent to avoid creating the risk of fire or an explosion.

V-BeltTension

The V-belt (Figure 25) can be adjusted by loosening the bearing block housing screws, and rotating the eccentric end bell housing until the desired tension is achieved. When the V-belt is properly tensioned, it should deflect approximately 5 to 10 mm when 5-10 pounds of force is applied centrally between the pulleys. Lock the countershaft in place with the locking screw and wing nut.

Figure 24. Engine Air Cleaner

3. Reinstall the filter and air cleaner cover.

Figure 25.V-Belt Tension

Quick Disconnect Lock

A small amount of any lightweight oil should be used on the locking mechanism (Figure 26) to help keep concrete from sticking and also to lubricate the locking pin and spring.

OIL

LOCK PIN

ECCENTRIC

END BELL

Figure 26. Quick Disconnect Lock

Pivot Assembly (Frame)

Using a grease gun, apply a couple shots of lithium base grease to the pivot bearing assembly as required.

PAGE 24 — BP-25H CE GASOLINE VIBRATOR — OPERATION MANUAL — REV. #4 (12/19/07)

Page 24
Image 24
Multiquip BP-25H CE manual Engine Air Cleaner, BeltTension, Quick Disconnect Lock