INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 11
TRANSMITTER/RECEIVER
The defi nitions below describe the controls and functions of the Miratron
Transmitter and Radio Control Receiver.

Transmitter

Power On Switch 1. — Place this switch in the ON position to turn on the
transmitter. Be sure to place this switch in the OFF position when the system
is not in use.
Status LED Indicator
2. — Status LED blinks to indicate transmitter is ON
and active. LED will double-blink when battery strength is low.
E-STOP Switch
3. — When activated will cause the engine stop and all
pumping will cease.
Belt Clip 4. — If desired the transmitter can be placed on a belt.
Pump ON/OFF Switch
5. — Place this switch in the pump ON position to
begin pumping. Place the switch in the OFF position to stop pumping.
Engine Speed Switch 6. — Place this switch upward to increase engine
speed. Place downward to decrease engine speed.
Batteries
7. — Transmitter requires four AA 1.5V alkaline batteries. If
rechargable batteries are to be used, nickel-metal hydride (NiMH) are
recommended.

Receiver (Learn Button)

Transmitter and receiver must be matched as a pair. Perform the procedure
listed below to pair the transmitter and receiver.
Place the ignition switch in the ON position.1.
Verify that the status LED on transmitter blinks (active).2.
Place the pumping control switch on the control box in the REMOTE ON 3.
position.
Press and hold the learn button on the RX4 radio control receiver. While
4.
keeping the learn button depressed, toggle the pump ON/OFF switch for
10 seconds.