Multiquip C30HDG Receiver Installation, Parts, Battery Disconnection, Ant enna Mounting

RECEIVER INSTALLATION

Parts:

Make sure all parts are accounted for before performing the installation.

The following parts are included with the kit:

Radio Transmitter

Radio Receiver

Spiral Antenna with associated mounting hardware

Coaxial Antenna Cable

Data /Power Cable (7-wire)

Remote Control Cable

Battery Disconnection

1. Disconnect the negative terminal of the battery cable from the battery.

Ant enna Mounting

1.Drill a 3/4” hole into the hood on the C30HDG as shown in Figure 1.

2.After hole has been drilled, deburr hole opening.

3.Tilt the engine hood slightly forward to gain access to the antenna hole opening. Support the hood with a block of wood to maintain the desired access position.

4.Insert antenna cable thru 3/4” hole opening in hood. Insert BNC end of cable fi rst.

5.With one hand holding the antenna end of the cable through the antenna hole opening, connect the locking fl ange, antenna and rubber gasket. Tighten locking fl ange securely.

6.Secure coaxial antenna with pressed on tie-wrap pads (interior). Also apply pressed on tie-wrap pads (exterior) to the control box support panel (bottom).

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 7