Multiquip HTN-27K-TCSL operation manual HTN-SERIES Rules for Safe Operation, Transporting, Battery

Models: HTN-27K-TCSL

1 46
Download 46 pages 4.37 Kb
Page 12
Image 12

HTN-SERIES — RULES FOR SAFE OPERATION

Transporting

ALWAYS shutdown engine before transporting.

Tighten fuel tank cap securely and close fuel petcock to prevent fuel from spilling.

Drain fuel when transporting trowel for long distances or over bad roads.

When placing the trowel on a truck-bed for transport, always tie-down the trowel.

If the trowel is being transported via a trailer, make sure the trailer complies with all local and state safety transportation laws. Refer to the following "Towing Safety Precautions" for basic towing techniques.

Towing Safety Precautions

CAUTION

Conform to Department of Transportation (DOT) Safety Towing Regulations before transporting trowel on public roads.

To reduce the possibility of an accident while transporting the trowel on public roads, always make sure the trailer that supports the trowel and the towing vehicle are in good operating condition and both units are mechanically sound.

The following list of suggestions should be used when towing your trowel:

Make sure the hitch and coupling of the towing vehicle are rated equal to, or greater than the trailer "gross vehicle weight rating" (GVWR) of 6,000 lbs.

ALWAYS inspect the hitch and coupling for wear. NEVER tow a trailer with defective hitches, couplings, chains, etc.

Check the tire air pressure on both towing vehicle and trailer. Trailer tires should be inflated to 50 psi cold. Also check the tire tread wear on both vehicles.

ALWAYS make sure the trailer is equipped with "Safety Chains ".

ALWAYS attach trailer's safety chains to towing vehicle properly.

ALWAYS make sure the vehicle and trailer directional, backup, brake, and trailer lights are connected and working

DO NOT exceed the recommended highway speed when towing. Unless posted otherwise, do not exceed 45 MPH highway, and 10 MPH off-road.

Use chock-blocks at each wheel when parked to prevent trailer from rolling.

Use the trailer's swivel jack to adjust the trailer height to a level position while parked.

Avoid sudden stops and starts. This can cause the trailer to skid or jack-knife. Smooth, gradual starts and stops will improve towing.

Avoid sharp turns.

Trailer should be adjusted to a level position at all times when towing.

Raise and lock trailer wheel stand in the "UP" position when transporting.

DOT requirements include the following: Connect and test electric brake operation.

Secure portable power cables in cable tray with tie wraps.

Battery

The battery contains acids that can cause injury to the eyes and skin. To avoid eye irritation, always wear safety glasses or face shielding. Use well insulated gloves when picking the battery up. Use the following guidelines when handling the battery.

DO NOT drop the battery. Any impact to the battery may cause it to explode.

DO NOT expose the battery to open flames, sparks, lit cigarettes etc. The battery contains combustible gases and liquids. If these gases and liquids come in contact with a flame or spark an explosion can occur.

ALWAYS keep the battery charged. If the

battery is not charged a buildup of combustible gas will occur.

ALWAYS keep battery cables in good working condition. Repair or replace all worn cables.

ALWAYS disconnect the negative battery terminal before performing service on the trowel.

ALWAYS recharge the battery in a vented air environment to avoid risk of a dangerous concentration of combustible gases.

In case the battery liquid, (dilute sulfuric acid), comes in contact with clothing or skin, rinse skin or clothing immediately with plenty of water.

In case the battery liquid, (dilute sulfuric acid), comes in contact with your eyes, rinse eyes immediately with plenty of water, then contact the nearest doctor or hospital and seek medical attention.

HTN-SERIESRIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #0 (06/06/07) — PAGE 12

Page 12
Image 12
Multiquip HTN-27K-TCSL HTN-SERIES Rules for Safe Operation, Transporting, Towing Safety Precautions, Battery

HTN-27K-TCSL specifications

The Multiquip HTN-27K-TCSL is a cutting-edge piece of technology designed for professionals in the construction and industrial sectors. This portable hydraulic power unit is known for its robust performance and versatility, making it an ideal choice for a wide range of applications.

One of the standout features of the HTN-27K-TCSL is its powerful engine. Equipped with a reliable 27-horsepower Kohler engine, this unit ensures maximum efficiency and performance, allowing operators to complete tasks quickly and effectively. The engine is designed to be both fuel-efficient and environmentally friendly, adhering to emission regulations without sacrificing power.

The HTN-27K-TCSL boasts a unique hydraulic system that delivers high-pressure flow rates, making it suitable for operating multiple tools simultaneously. With a maximum hydraulic pressure of 3,000 PSI, this power unit can effortlessly handle demanding tasks such as concrete breaking, water jetting, and other heavy-duty applications. The ability to provide consistent hydraulic power allows for enhanced productivity on job sites.

In terms of versatility, the Multiquip HTN-27K-TCSL is equipped with a wide range of output options. Its hydraulic outlet configurations can support various attachments, enabling users to adapt the unit for diverse tasks. This flexibility makes it an invaluable tool for contractors, landscapers, and utility companies.

Another notable characteristic of the HTN-27K-TCSL is its rugged construction. Built to withstand the rigors of tough job sites, this hydraulic power unit features a durable frame and protective covers that shield the engine and components from dust and debris. The compact design ensures easy transportation and maneuverability, making it a practical choice for both indoor and outdoor use.

Additionally, the HTN-27K-TCSL is designed with operator safety in mind. It features a user-friendly interface, with clearly labeled controls for easy operation. Safety features such as emergency shut-off switches and protective guards further enhance its usability, ensuring that operators can work confidently.

In summary, the Multiquip HTN-27K-TCSL is a powerful, versatile, and robust hydraulic power unit designed to meet the demanding needs of various industries. With its exceptional performance, durable construction, and focus on safety, it continues to be a trusted choice among professionals seeking reliable hydraulic solutions.