Multiquip Model WM45H manual Initial Start-up Engine

Initial Start-up (Engine)

CAUTION

DO NOT attempt to operate the mixer until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.

This section is intended to assist the operator with the initial start-up of the mixer. It is extremely important that this section be read carefully before attempting to use the mixer in the field.

1.Place the engine fuel valve lever (Figure 7) to the “ON” position.

Figure 7. Engine Fuel Valve Lever (ON Position

2.Move the throttle lever (Figure 8) away from the slow position, about 1/3 of the way toward the fast position

Figure 8. Throttle Lever (1/3 Start Position)

3.Place the choke lever (Figure 9) in the “CLOSED” position if starting a cold engine.

Figure 9. Engine Choke Lever (Closed)

4.Place the choke lever (Figure 10) in the “OPEN” position if starting a warm engine or the temperature is warm.

Figure 10. Engine Choke Lever (Open)

5.Place both engine ON/OFF switches (Figure 11) in the “ON” position.

Figure 11. Engine ON/OFF

Switches (ON Position)

WM45H/E PLASTER MORTAR MIXER • operation and parts manual — rev. #0 (09/27/12) — page 17