Maintenance (mixer)
Drum Head Seals
There is 1 set of drum head seals (Figure 23) that will require lubrication.
NOTICE
Important- Drum Head Seal Care
Grease seals every 40 hours of operation using any grade #1 lithium base grease. Apply grease until visible of mixing tub (over grease). This will purge seal system of contamination.
Figure 23. Grease Fittings (Drum Head Seals)
Drum Bearing Bracket Lubrication
There is 1 set of drum bearing brackets (Figure 24) that will require lubrication. These brackets are intended to make the drum rotate freely. Lubricate the grease fitting for each drum bearing bracket every month or when the drum becomes difficult to position using
Figure 24. Grease Fittings
(Dumping Mechanism)
NOTICE
Lubricating Grease Fittings
Failure to lubricate the drum bearing grease fittings periodically will cause the dumping mechanism to stiffen, making the mixing drum hard to dump.
Countershaft Bearing Lubrication
There is 1 set of countershaft bearings (Figure 25) that will require lubrication. Lubricate the grease fitting for each countershaft bearing every 40 hours of operation using any grade lithium base grease.
Figure 25. Grease Fittings (Countershaft)
Grease Fittings (Zerk) Maintenance (Electric Motor)
1.1.There are two grease (Figure 18) fittings at each end of the electric motor that will require lubrication. Lubricate these fittings about every 16 months.
2.Use Poleyrex EM (Exxon Mobil) or equalivant lubricant. Clean grease fitting, apply grease gun to fitting (1/2 shot). Remember too much grease or injecting grease too quickly can cause premature bearing failure. Slowly apply the recommended amount of grease, taking a miniute or so to apply.
Figure 26. Grease Fittings Electric Motor
page 22 — WM45H/E PLASTER/MORTAR MIXER • operation and parts manual — rev. #0 (09/27/12)
