Multiquip manual MQ41TDH Initial START-UP Engine

MQ41TDH — INITIAL START-UP (ENGINE)

CAUTION :

DO NOT attempt to start the engine unless the pump has previously been primed with water. Severe pump damage will occur if pump has not been primed.

4.If engine oil is low, fill engine crankcase with lubricating oil through filler hole (Figure 3), but do not overfill.

5.The oil listed in Table 3 is recommended to ensure better engine performance. Use class CD or higher grade motor oil.

Engine Oil

1.Make sure pump/engine is on level ground.

2.Pull the engine oil dipstick (Figure 3) from its holder.

	F	C
	122	50
ENGINE OIL	104	40
DIPSTICK
	86	30
	68	20
HOLDER	50	10
	32	0
	-14	-10
	-4	-20
	-22	-30
	-40	-40

Figure 3. Dipstick Location

3.Verify that oil level (Figure 4) is maintained between the two notches on the dipstick.

Table 3. Oil Selection Chart

OIL: SAE

	5W/40							40
5W/30			10W/30	10W/40	15W/40		30
						20W/20
		10W

Figure 4. Engine Oil Dipstick

PAGE 16 —MQ41TDH TRASH PUMP — PARTS & OPERATION MANUAL — REV. #3 (04/02/07)