Multiquip manual MVC-90HPLATE COMPACTOR - INSPECTION, Fuel Check, WARNING - Explosive Fuel

MVC-90H PLATE COMPACTOR — INSPECTION

Fuel Check:

1.Remove the gasoline cap located on top of fuel tank.

2.Visually inspect to see if the fuel level is low. If fuel is low, replenish with unleaded fuel.

3.When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately!

WARNING - Explosive Fuel

Gasoline is extremely flammable, and its vapors can cause an explosion if ignited. DO NOT start the engine near spilled fuel or combustible fluids.

DO NOT fill the fuel tank while the engine is running or hot. DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system. Store fuel in approved containers, in well-ventilated areas and away from sparks and flames.

Vibrator Oil Check

1.Place the plate compactor horizontally on a flat surface. Make sure the compactor is level when checking the oil in the vibrator assembly.

2.Check vibrator oil level by removing the plug (vibrator oil gauge) as shown in Figure 7. The oil level should be up to the oil plug. The vibrator holds 140 cc (approxi- mately 4 oz).

NOTE	When adding or replacing oil, re-
	place using only SAE 10W-30
	motor oil.

Figure 7. Vibrator Oil Plug

V-Belt Check

CAUTION - Checking and Replacing the V-Belt

NEVER attempt to check the V-belt with the engine running. Severe in- jury can occur if your hand gets caught between the V-belt and the clutch. Always use safety gloves.

1.To check the V-belt tension, remove the three bolts that secure the belt cover to the frame as shown in Figure 8.

Figure 8.V-Belt Cover Removal

2.The V-belt tension is proper if the V-belt bends 10 to 15 mm (Figure 9) when depressed with finger at midway between the clutch and vibration pulley shafts.

Figure 9.V-Belt Tension

3.A loose V-belt will decrease the power transmission output, causing reduced compaction and premature wear of the belt.

4.If the V-belt becomes worn or loose, replace it .

PAGE 18 — MVC-90H PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #3 (01/10/11)