Multiquip MVH-120GH manual Belt Check, Belt Hazard

Vibrator Oil Check

1.With handle bar positioned vertically (storage position), remove the breather cap (Figure 6) from the breather plug.

2.Use a 24 mm wrench and remove breather plug (Figure 6). Visually check to see if hydraulic oil comes up to the oil level line that is etched on the back side of the handle.

CAP

BREATHER

PLUG

OIL LEVEL

HAND PUMP

Figure 6.Vibrator Oil Gauge

2.If the hydraulic oil level is low, replace with "Shell Tellus" oil #46 or equivalent.

V-Belt Check

CAUTION

NEVERattempttochecktheV-beltwiththeenginerunning. Severeinjurycanoccurofyourhand(Figure7)getscaught betweentheV-beltandtheclutch.Alwaysusesafetygloves.

CLUTCH

PULLEY

VIBRATOR

PULLEY

Figure 7.V-Belt Hazard

MVH-120GH — INSPECTION

1.To check theV-belt tension (Figure 8 ), remove upper belt cover.

Figure 8.V-Belt Location

2.The V-belt tension is proper if the V-belt bends 10 to 15 mm (Figure 9) when depressed with finger at midway between the clutch and vibration pulley shafts.

Figure 9.V-BeltTension

3.A loose V-belt will decrease the power transmission output, causing reduced compaction and premature wear of the belt. V-belt in use is RPF-3320 (A-32 is also usable).

4.If the V-belt becomes worn or loose, replace it by using V- belt part number RPF-3320 or A-32.

MVH-120GH — OPERATION AND PARTS MANUAL — REV. #03 (10/24/07) — PAGE 15