Multiquip manual MVH-200DA2 - MAINTENANCE, CAUTION - General Maintenance Safety, Daily Service

MVH-200DA2 — MAINTENANCE

CAUTION - General Maintenance Safety

Inspection and other services should always be carried out on hard and level ground with the engine shutdown.

Inspection and Maintenance ServiceTables.

To make sure your plate compactor is always in good working condition before using, carry out the maintenance inspection in accordance with Tables 5 through 7.

TABLE 5. MVH-200DA2 MACHINE INSPECTION

ITEM	HOURS OF	REMARKS
	OPERATION
Loose or Missing	Every 8 hours
Screws	(every day)
Damaged Parts	Every 8 hours
	(every day)
Function of Controlling	Every 8 hours
System Part	(every day)
Hydraulic System Leak	Every 100 hours
Vibrator Oil Check	Every 100 hours	See page 21
Vibrator Oil	Every 300 hours	See page 21
Replacement
Hydraulic Oil Check	Every 100 hours	See page 23
Hydraulic Oil	First after 200
	hours, then every	See page 23
Replacement
	1,000 hours
V-belt (clutch) Check	Every 200 hours	See page 22

	These inspection intervals are for
NOTE	operation under normal conditions.
	Adjust your inspection intervals
	based on the number hours plate
	compactor is in use, and particular
	working conditions. Fuel piping and
	connections should be replaced
	every 2 years.

TABLE 6. MVH-200DA2 ENGINE CHECK

ITEM	HOURS OF OPERATION
Spark Plug Check	Every 40 hours (every week)
Oil or Fuel Leak	Every 8 hours (every day)
Tightness of Fastening	Every 8 hours (every day)
Threads
Engine Oil Check and	Every 8 hours (every day)
	(Replenish to specified maximum
Replenishment
	level)
Engine Oil Replacement	After first 25 hours then every 50 to
	100 hours
Air Filter Cleaning	Every 100 hours

See separate engine manual for details on engine check.

Daily Service

zCheck for leakage of fuel or oil.

zCheck for loose screws including tightness. See Table 7 below (tightening torque ), for retightening:

TABLE 7.

TIGHTENING TORQUE (in. kg/cm) Diameter

Material	6mm	8mm	10mm	12mm	14mm	16mm	18mm	20mm
4T	70	150	300	500	750	1,100	1,400	2,000
6-8T	100	250	500	800	1,300	2,000	2,700	3,800
11T	150	400	800	1,200	2,000	2,900	4,200	5,600
*	100	300~	650 ~
		350	700

* (In case counter-part is of aluminum)

(Threads in use with this machine are all right handed)

Material and quality of material is marked on each bolt, and screw.

zRemove soil and clean the bottom of compaction plate.

zCheck hydraulic pump, piping and hose for any leakage. A loosened hydraulic hose can be a cause for leakage. Check hydraulic hose connections with wrench applied for tightness.

zCheck engine oil.

PAGE 20 — MVH-200DA2 PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (01/27/06)