Multiquip MVH306GH Operation, Releasing the Handle, Handle Release Pin Adjusting Handle Height

OPERATION

CAUTION

DO NOT attempt to operate the compactor until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.

This section is intended to assist the operator with the initial start-upof the compactor. It is extremely important that this section be read carefully before attempting to use the compactor in the field.

Refer to Figure 4 for the location of controls and components.

Releasing the Handle

1.Pull the handle release pin, (Figure 12) then push down on the hand grip to release the handle.

Figure 12. Handle Release Pin

Adjusting Handle Height

The height of the handle is adjustable for your comfort .

1.Loosen the butterfly screw (Figure 13).

2.Turn the grip clockwise to raise the handle or counterclock- wise to lower the handle.

3.When the handle is raised to the desired height, tighten the butterflyscrew.

Figure 13. Handle Adjustment

STARTING THE ENGINE

Starting the Engine (HONDA engine)

1.Place the engine fuel valve lever (Figure 14) to the "ON" position.

Figure 14. Engine Fuel Valve Lever (ON Position)

2.Move the throttle lever to the START position (Figure 15).

Figure 15. Throttle Lever (Start Position)

PAGE 18 — MVH306GH PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #8 (01/31/14)