operation
7.If the engine fails to start, DO NOT continue to rotate the ignition key for more than 5 seconds. Return the key to the RUN position and wait 10 seconds before starting again
STOP |
RUN |
START
Figure 14. Starter Switch (Option)
;
CAUTION
While the engine is running, never try to turn the ignition key to the START position.
8.After starting the engine, continue to warm up the engine for about 3 to 10 seconds especially in cold weather.
9.If the buzzer does not stop sounding after the engine has started, shutdown engine immediately and check engine oil level. The buzzer functions as a engine oil level alarm warning device.
Recoil Start
1.Place the throttle lever (Figure 13) in the START position (center).
2.Place the travel lever in the neutral position (center).
3.Grasp the starter grip (Figure 15) and slowly pull it out. The resistance becomes the hardest at a certain position, corresponding to the compression point. Pull the starter grip briskly and smoothly for starting.
21
Figure 15. Engine Start Handle
4. If the engine does not start, repeat steps 1 through 3.
TRAVELING
CAUTION
Make sure to follow all safety rules referenced in the safety section of this manual before operating compactor. Keep work area clear of debris and other objects that could cause damage to the compactor or bodily harm.
1.Grasp the compactor's hand grip, and move the engine throttle lever (Figure 16) quickly to the fast position.
2.With the throttle lever in the fast position, the engine speed should be around 3,600 RPM, therefore engaging the centrifugal clutch.
HAND
GRIP
FULL THROTTLE
POSITION
Figure 16. Throttle Lever (Fast)
NOTICE
ALWAYS move the throttle lever quickly without hesitation, because increasing the engine speed slowly causes the clutch to slip.
3.To make the compactor move in the forward direction push the travel lever ( Figure 17) forward.
TRAVEL
LEVER
NEUTRAL
REVERSE
FORWARD
Figure 17. Travel Lever
mvh406dsz/dsCPAs pLATE COMPACTOR • operation and parts manual — rev. #7 (02/28/14) — page 19
